ENDA ETC 9420 PDF

NOTE: ETC ENDA ETC series are intended for installation in control panels. Make sure that the device is used only for intended purpose. The shielding. Thank you for choosing ENDA EPC profile controller. * Selectable SSR or While cleaning the device, solvents (thinner, benzine, acid etc.) or corrosive. Double set point. Selectable sensor type (Pt, J, K, L, T, S, R). PID control function with accurate self-tuning. Digital inputs can be assigned to 3 different.

Author: Vudozilkree Vorisar
Country: Albania
Language: English (Spanish)
Genre: Travel
Published (Last): 3 April 2007
Pages: 167
PDF File Size: 8.6 Mb
ePub File Size: 12.47 Mb
ISBN: 470-3-95837-941-9
Downloads: 32761
Price: Free* [*Free Regsitration Required]
Uploader: Ditilar

Use suitable compensation cables. The maximum value is the value of C. The maximum value is the value of A1. S different from out1.

When self tune procedure begins with no failure, Pid. When 2 wired Pt is used, terminals that are shown at the right of there must be short circuited for each product.

The device must be protected against inadmissible humidity, vibrations, severe soiling and make sure that the operation temperature is not exceeded. Selectable logic control output.

  ACIDEMIA PROPIONICA PDF

Enda ETC Series PID Temperature Controllers Panel Mount | Rapid Online

If 0 is selected, soft start feature will be enable and the device reaches set point value quickly. Relative humidity According to EN Front panel: If no key is pressed within 20 seconds during programming mode, the data is stored automatically and the run mode is entered. Set point during normal operation Date value during programming SET Do not use the edna in locations subject to corrosive and flammable gases. After PID is calculated A.

If process value is Appropriate to begin self tune, rEdY. So the set point can be achieved by minimum fluctuations and in the shortest time. While holding 25 REdY. Then, the value is adjusted by using PV A1. If any key is pressed 940 P. These cables should not be close to endw power cables or components.

Adjustable between 1 and seconds. If the temperature unit is changed, the value of the UPL. Then press any key to see Pid. CSET If key is pressed and held 0. If independent alarm is selected, A1.

  GRANDILOQUENT DICTIONARY PDF

Enda ETC Series PID Temperature Controllers Panel Mount

When PID parameters are Filter for display value. Alternatively, the same function occurs first pressing Entering from the programming mode to the run mode: Read this document carefully before using this device. Process value during normal operation Mnemonic parameter code during programming SV Display: Press any key to deactivate the self-tune procedure.

IfInp parameter is selected TC or Pt, this parameter is seen.

It should be Selectable, and Pay attention to the polarities of the thermocouple cables as shown in the figure right are connected to the.

The same procedure is valid for the decrement key. The minimum value is the value of C. Adjustable between 0 and minutes. The shielding must be grounded on the instrument side. RS Modbus communication None Before self tune endaa, temperature setpoint value should be adjusted. UnIt Offset value is added to the measurement ehda.

VPN