Instruction manual of EZM Programmable Counter consists of two main . EMKO Elektronik warrants that the equipment delivered is free from defects in. BUT it’s a negative number and I cannot figure out what to do? HELP PLEASE? EMKO ESM Temperature Controller-img_jpg. ESM, ESM, ESM, ESM, ESM ESM 8 mm. Green 4 EMKO Elektronik warrants that the equipment delivered is free from.
|Published (Last):||22 March 2016|
|PDF File Size:||18.91 Mb|
|ePub File Size:||10.77 Mb|
|Price:||Free* [*Free Regsitration Required]|
Yes the bottom value is setting the maximum temp it will reach before the gas gets cut off.
If you can may not be possible you could unplug the thermocouple from the controller and plug into the handheld device. I would hope that the manufacturer would tell you this.
Process Controllers – ESM/ | HTA Instrumentation (P) Ltd.
When you said ” check is to see if the thermocouple type is set properly in the controller” In my scenario I could route my cabling to this device when I was having issues How do I check this? Its the wiring problem you have to opposite the wire in emio the temperature controller. Your thermocouple is likely disconnected or has a broken wire.
The one in my older toper flashes the display at loss of continuity, the phidget shows a negative number. Obviously be careful you turn on your drum and its cold Hi dear I just read your post about toper drum tempreture. I am technically challenged but could tell me how to test the thermocouple exactly?
Hello Fellow Roasters, we just received our Toper 15 kilo roaster from Turkey and could not be more excited to start roasting.
The time now is Originally Posted by fivestarcoffeeroasters. I own toper cafemino. But after using toper i discover they use J type thermocouple and honestly its very thick and gave low value for tempreture. BUT it’s a negative number and I cannot figure out what to do?
Charlie If you are afraid of failure or losing money, quit while you are ahead. I would assume the bottom value that you are setting is the maximum temperature it will reach before cutting off the gas valve fire safety feature. I use different thin thermocuple connected with Phidget All times are GMT One you know es-m4430 type you have you need to go into the controllers settings to see if it’s setup for that type of thermocouple.
Esj-4430 new then contact Toper. You can test a thermocouple with a multimeter, it should read a few ohms, I would suggest a disconnected probe or bad connection at the controller?
EMKO ESM Temperature Controller
Steve Green Mill City Roasters. Results 1 to 9 of 9. If you take a look at the attached picture If you have a electronic multimeter it may have an input for thermocouples.
I have the pre-set temp at but the top number emmko read the current temp of the drum Second thing I would check is to see if the thermocouple type is set properly in the controller.
They have excellent customer service. Some temp controllers indicate a bad or disconnected thermocouple differently.
Can you reach the thermocouple inside of the drum? Thanks for your help!
HTA Instrumentation (P) Ltd.
Can you shoot me a link or something to a hand held device I could purchase to use? It’s odd that its showing negative You may fix it for sure. So first thing you need to do is check the type of thermocouple you have