ptcl router manual. An User Manual Router All materials on our website are shared by users. If you have any questions about. USER MANUAL. TestClick ADSL BER Test to perform a bit error rate (25 26Note: If the BER reaches e-5, you cannot access the Internet. Find the default login, username, password, and ip address for your Fiber Home AN router. You will need to know then when you get a new router.

Author: Kektilar Moll
Country: Senegal
Language: English (Spanish)
Genre: Science
Published (Last): 25 July 2012
Pages: 362
PDF File Size: 5.21 Mb
ePub File Size: 13.49 Mb
ISBN: 750-4-39238-985-1
Downloads: 40517
Price: Free* [*Free Regsitration Required]
Uploader: Vudohn

The following questions have been merged into this one.

How to Login to the FiberHome AN

Can not log on to the configuration page 3. It supports eight characters at most.

Yes, but how should i do that. It looks like this: Please check and try again. But the general step for this is you have to login to the browser page of your router and an10200-25 go to wireless settings and then security settings, you can then put a security key or password then save the settings. Please unmerge any questions that are not the same as this one: Input the following IP address: The unit value is set in second.

When using USB Interface, you must install the drivers. Chemistry Engineering Mathematics Physics.

FiberHome AN1020-25 User Manual

Please help us improve our content by removing questions that are essentially the same and merging them into this question. I have my ptcl wifi connection and wants to know how can i may connect it with my q tablet It is adapted for strict requirement to delay and quality of data packets transmission. To lock your wireless internet, you have to refer usser the instruction of your wireless router.


Was this comment helpful? Leader Board What’s this? After the modification, the maximum transmission unit can reach Launch a browser and type in the default gateway address 5.

Hi, the hser button is located on top in the middle of the router that looks like an inverted up and down arrow.

Drivers and Software

I forgot my ptcl modem user name or pasword so i reset this please tell me? Then try to connect to your wireless network and input the WEP key when prompted.

In this page, you can set the status of the DHCP server. You will have to check your connection setting and ensure its in 3G or a higher version, the setting depends on your service provider. The upload speed is up to 1Mbps and download speed is up to 8Mbps.

Wifi-modem an firmware upgrade required? It is offensive or harmful. I found a document on the wateen site that may help you out. If any one of them is missing, please contact the vendor immediately. Community Experts online right now. There an1020-225 be a reset button on your modem or on and off switch to reset you modemnow for the password and user name usually it isuser: When you are sure that your configuration is correct, click Apply.


The user can configure these addresses through the Local Network page. Hi there, you can use your laptop as your hotspot, or you can also try reverse tethering. It is offensive or harmful. The frequency of ADSL signal is higher than that of voice, so voice and ADSL manuwl can coexist in one line by using a splitter to insulate each from the other. Make sure the user name and password is correct.

Fiber Home AN Default Router Login and Password

By default, it is not selected. In the Connections page, the default configuration of the modem supports seven PVCs. This is NOT abusive. Please tell us which questions below are the same as this one: Click Control Panel 3. When prompted for the username and password check your manual for the default settings which are usually user admin with no password.

Choose the connection protocol of the An1002-25 Routed.

In this page, you can modify the DHCP server settings. All of the default usernames and passwords for the FiberHome AN are listed below.

It will ask you to clickYesto confirm deletion.